HONDA

REAR INSTALLATION INSTRUCTIONS

CBR F2-F3

STEP 1. REMOVE THE FACTORY TAIL SECTION

STEP 2. CUT THE REAR PLASTIC FENDER TO LOOK LIKE THE PICTURE

STEP 3. MAKE SURE YOU CUT THE PLASTIC FENDER TO LOOK LIKE THIS

STEP 4. THIS IS WHERE YOU MOUNT THE FENDER ELIMINATOR KIT TO THE

BOTTOM OF THE TRUNK

STEP 5. YOU WILL HAVE TO BRILL 3 HOLES TO MOUNT THE FENDER ELIMINATOR KIT

LIKE SHOWN IN THE PICTURE

STEP 6. CONNECT THE FACTORY WIRING TO THE LED WIRING

THE GREEN WIRES ARE NEGATIVE

BLUE AND ORANGE WIRES ARE POSITIVE

THE BROWN IS NEGATIVE FOR THE TAG LIGHT AND THE GREEN IS POSITIVE

THIS IS WHAT YOUR FENDER ELIMINATOR SHOULD LOOK LIKE

**PATENTS PENDING**

Copyright Notice
The images and other content contained in this web site are the property of and copyrighted by Fenderliminator Inc., unless otherwise indicated.  Permission is granted for the download of images for an individual's personal use, as long as that use is not commercial.  Copyright © 2004 Fenderliminators inc.  All rights reserved

How Does Copyright Protection Work?
Read this excellent overview of international copyright law by www.WhatisCopyright.org.

Customer Service: Service10@1Tail.com   612-524-5459