Kawasaki Installation Instructions
Concours Footpeg Lowering Brackets

Note: the bracket with the 'extra' notch goes on the left side footpeg.

1. Remove the clip and pull out the pin that holds the footpeg on. On the left side you will need to remove the foot be bracket so you can pull out the pin. On the left side repin the footpeg lowering bracket to the stock footpeg bracket and bolt back to the frame. Remove the right side footpeg bracket. Pin the footpeg lowering bracket to the stock footpeg bracket. Do Not reinstall yet.

2. Remove the two allen bolts that hold the rear brake hydraulic system and brake pedal linkage. You will need to re-adjust the brake pedal linkage to fit. On most riders it will need to be adjusted all the way down. You can remove the lock nut for more reach. Reinstall the right side footpeg and bracket. Use the stock pins on the top of the footpeg bracket and the bolts on the bottom, at the footpeg.

3. You will nee to re-adjust the the gear shift, also. At the front of the gear shift there is a rubber dust cover, over the shaft. Under the dust cover is a clip to hold the gear shift on the shaft. Remove this clip. Remove the linkage to the rear of the gear shifter. This is held on the gear shift shaft with a 10mm bolt. Pull both ends off of the two shafts and reposition to move the gear shifter at leat one notch down.

4. Adjust both the gear shift and the brake to fit you. Remember to adjust the brake light switch. (Remove the right side cover that covers the battery. Under it, at the bottom, you will find the brake light switch.)

Email questions to: Service10@1Tail.com   To place your order by phone: 303 872 0329

Phone hours: Monday through Friday: 10:00 am to 5:00 pm (MST) Para toda la gente que habla español: Llámenos o mándenos un email. Se habla español.