748, 916 and 998 Fender Eliminator Kit '99-'02
Fits '99 through '02 748/916/998. Kit comes with signals.
Two kits in one mean you can mount the license plate forward by the shock (bottom picture--hard to see) or rearward (top picture). Comes with everything needed to wire the license plate light light too.
This item usually takes about 1 to 2 days to ship
Item no. 1D916
Retail: $159.95(PLUS shipping)
Today$151.95
Application Chart Diagrams
Application
1999 Ducati 748
2000 Ducati 748
2001 Ducati 748
2002 Ducati 748 Biposto
1999 Ducati 916
2000 Ducati 916
2001 Ducati 916
2002 Ducati 916
1999 Ducati 998
2000 Ducati 998
2001 Ducati 998
2002 Ducati 998 Biposto
WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations.
The Q&A on this Product
QUESTION: Do you have a kit that will fit a 2004 800SS?
ANSWER: sorry, no.
QUESTION: Do you have a kit for the 1098?
ANSWER: yes.... 1D1098
QUESTION: do you have a fender elimator for a 2000 900 SS?
ANSWER: Its been discontinued
QUESTION: I'm looking for a Fender Elininator kit for a 2001 Ducati 750 Sport. I'm told other ducati models will fit.
Any ideas what kit would work?
ANSWER: No nothing available.
QUESTION: Does the Fender Eliminator kit for the 916 or 998 fit on a 01 996 rs?
ANSWER: yes
QUESTION: Do you have any kits avail. for 1996 900 SS/SP?
ANSWER: Sorry, its been discontinued.
QUESTION: what kind of lights are in the turn signals now, are they led's or can they be led's
ANSWER: The lights are not LED's but they are nice and bright. No LED's available.
QUESTION: do u have instructions of what the setup looks like, instructions, etc.
ANSWER: We do not send photos of the actual kit. The photos on the site show an installed kit.
QUESTION: How does the lic. bracket mount in the top pic. Via the light or the stock 3 bolt system?
ANSWER: It uses the stock three bolts, and picks up additional support from your exhaust mount.
QUESTION: How do the turn signals mount in the second picture under the rear vents under the seat? Also, do I need to do any drilling for the license plate mount?
ANSWER: Our signal brackets mount to the seat post. There is a little drilling for wiring.
Ask your question here:
Your email (so we can send you the answer):
powered by
