8mm SWINGARM SLIDER SPOOLS (set of 2)
Make the most of your rear stand!! Woodcraft swingarm spools are designed wide for easy stand location with raised lips on their outer edges for security. Your stand will work even better when coupled with these spools.
This item usually takes about 2 days to ship
Item no. 27-3800
Today$38.75
WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations.
The Q&A on this Product
QUESTION: So these would fit 2008 honda cbr600rr??
ANSWER: Yes but they need a spacer, which we have, to work with your specific bike.
QUESTION: What is the dimension of the center portion?
My stand has a little cradle for the spools and I need to know if it'll fit in there.
ANSWER: The center diameter is .580
QUESTION: do these fit 07 hayabusa? thanks
ANSWER: They should, Although I have not seen the Busa, every Suzuki for the past 10 years has used 8mm spools
QUESTION: can you get these in anodized blue? if not can you attach the blue woodcraft pucks to these?
ANSWER: Yes, they are avaialble in blue and you can get sloder tops to match.
QUESTION: will these fit my 2007 GSXR and how easy are they to install
ANSWER: Yes, it takes about 60 seconds to install them.
QUESTION: Are this for stands or are they sliders also?
ANSWER: These are stand spools that also act as sliders
QUESTION: Is this ok for a gsxr600 k6. Cheers.
ANSWER: Yes, they will work on almost all GSXR's
QUESTION: Are these 8x1.25 thread? ducati 999R fitment
ANSWER: Yes, they are standard 8mm thread - if your swingarm is tapped with 8mm holes (not all 999's are) then these will fit.
QUESTION: Is this the right size spool for a 01 cbr 600 f4i?
ANSWER: If your bike has a place to receive swingarm spools, all Hondas are 8mm. I am not sure if every F4 had them, so check your bike to be sure.
QUESTION: hi, would these spools fit a ducati 999?... and what would the carge be for shipment to sydney, australia?
ANSWER: Yes, they will fit - but for shipping to Autralia please contact 1tail
Ask your question here:
Your email (so we can send you the answer):
powered by
