Aprilia RSV/R - Tuono/Factory/R 2007 Factory/R Rearsets w/GP Shift Pedal
The basic rearset kit consists of the rearset plates, footpegs and all of the needed hardware to install the kit properly. A special CFM shift pedal, shift rod and knuckle are provided so that you can ride with a GP shift pattern (1 up, 5 down). These kits assume that you currently have the OEM rearsets on your bike, and utilize the OEM shift and brake pedals. A special CFM eccentric adjuster is provided so that you can adjust the position of the brake pedal tip. These rearsets are made from tough, aircraft grade 6061 T6 Aluminum. They are much stronger than OEM brackets and will give your bike a look that will separate you from the crowd. Each kit is individually designed for your model of motorcycle to give you the optimum foot position and ground clearance for racing.
Moves pegs up and back 1/2"
This item usually takes about 14 days to ship
Item no. 05-0722
Retail: $349.99(PLUS shipping)
Today$344.95
Why buy a BRAKE PRESSURE SWITCH ASSY? Coarse or Fine?
These universal switches allow rearset users to operate the rear brake light. This all-in-one unit replaces the banjo bolt that connects the rear master cylinder to the rear brake line. You simply replace the bolt with this assembly and splice the wires into your existing brake light switch. The pressure inside your brake system then activates the brake light.
This part is a MUST HAVE item if you are going to ride your Woodcraft Race Rearset equipped bike on the street. Woodcraft Race Rearsets do NOT have a mount for your brake light switch linkage. This switch comes with a replacement banjo bolt and a pressure sensor switch that senses when pressure is applied, and triggers your brake light. The thread pitch can vary between different bikes IN THE SAME MODEL YEAR. Please make certain which thread pitch your specific bike has before ordering.
NO RETURN OR REFUND ON THIS ITEM!
WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations.
The Q&A on this Product
QUESTION: Hi Dan, this is Jim Brewer. Will this fit the RSV/R Factory Aprilia & do you have it in stock? Thanks much!
ANSWER: Yes, it will fit your bike and Woodcraft has them in stock, so we can get them right out to you.
Ask your question here:
Your email (so we can send you the answer):
powered by
