Sound whether in the form of audio waves from both low and high decibel frequencies or from bass vibrations, road rattle and engine noise disrupts the sound waves we would rather hear. BOOM Mat can now aid in filtering sound quality by absorbing much of the distortion caused by these disruptive sound waves by reducing their caustic effect against the sounds we would rather hear.
	BOOM Mat's unique ability to absorb the unwanted noise and sound waves drastically improves the enhancement of audio sound performance, eliminating both road and engine noise while also dampening the vibrations that tunnel and surround audio output. No surface preparation is required and it's easy to install! Just simply trim to desired size and shape, peel backing and apply.

DEI BOOM Mat™ FAQ

What is the temperature range of BOOM Mat™?
BOOM Mat™ maintains adhesion from -30°F to 400°F and does have thermal reflective and insulation-like properties capable of being used as an intermediate heat shield barrier.

How much BOOM Mat™ will I need?
The amount of BOOM Mat™ required depends on the installers specific needs. Audio competitors would require BOOM Mat™ on all areas of a vehicle including trunks, floor, firewall, inside dash panels, door panels and even the ceiling. For installers just wanting to minimize road vibrations and exhaust noises we recommend cutting BOOM Mat™ into 6" squares and applying them to areas where noise and vibrations are the most prevalent.

How effective really is BOOM Mat™?
A BOOM Mat™ demonstration that DEI commonly uses during an event includes a small 1" inch square applied to a large 20" inch percussion cymbal. When the cymbal is struck it products virtually no noise - only a short low pitched clank when forcefully struck with a drum stick - and that's only with a 1" square piece of BOOM Mat™!

What tools are needed to install BOOM Mat™?
A BOOM Mat™ requires little prep work. A razor or scissors and a roller will be required. You may also need basic hand tools to remove door panels and trim. As with any adhesive material the surface must be free of any debris. Once cleaned, use a razor or scissors to cut BOOM Mat™ into the desired shape necessary for the area of coverage. The roller can be used to evenly apply pressure on all surfaces to ensure proper adhesion.

What are the available sizes and is there bulk sizing available also?
The basic kit includes 2 (two) 12" x 11-1/2" sheets of Boom Mat PN # 50200. PN # 50202 has 4 (four) sheets of 12" x 11-1/2" Boom Mat. PN # 50204 has 8 (eight) sheets of 12" x 11-1/2" Boom Mat. Bulk sizing come in 12" x 23" sheets, in either a 6 (six) pack PN # 050206, 10 (ten) pack PN # 050210, or a 20 (twenty) pack PN # 050212.