Daytona 675 Fender Eliminator 2006
Pivot mounted kit, with new LED license light, and turn signals.
This item usually takes about 1 to 2 days to ship
Item no. 1T675
Retail: $139.95(PLUS shipping)
Today$136.95
WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations.
The Q&A on this Product
QUESTION: will it fit the 2009 model
ANSWER: yes
QUESTION: is there a light which illuminates the rego plate?
ANSWER: whats a rego plate? There is a LED license light as stated.
QUESTION: This may be a dumb question but, is it safe to assume that I can use this kit on the 2007?
ANSWER: Yes it fits through 07
QUESTION: Are those turn signals LED?
Thanks,
Gena.
ANSWER: no.....standard bulbs
QUESTION: hi what size plate will fit on the eliminator? a standard plate here is 8" x 6".. many thanks.
ANSWER: 4x7 standard USA plate
QUESTION: I would like to know if I can use it in France, if the french police accepts it and of course if it's approved for France.
ANSWER: Good question. You'd need to check with your DMV for regulations.
QUESTION: I thought the license plate is mounted on the rear hugger/mudguard, rather than the swingarm?
ANSWER: It uses the mounting points for the hugger..... but mounts above the hugger on special spacers.
QUESTION: It looks like the license plate is mounted to the passenger foot peg holes. Can the passenger footpegs be on at the same time as the plate?
ANSWER: It's mounted to the swingarm........
QUESTION: How are the turn signal LED's wired? I don't see any wires coming out of them.
ANSWER: The wires are in the storage area
QUESTION: Instead of putting the turn signals on the heat sheild is there any way to put them on the license plate bracket? Also, instead of using the original turn signals that comes with the set can I use a different pair of after market signals and put them around the license plate bracket?
ANSWER: These signals mount withe two sided tape. You can put the anywhere you want.
QUESTION: How are the "new" lights connected to the heat sheild?
ANSWER: two sided 3m tape
QUESTION: May I purchase only the tag bracket and not the turn signals
ANSWER: Only through Comp Werkes
QUESTION: The original brace that holds the plate and signals is absent here (in your photo). Isn't that metal strap necessary to hold the exhaust up under the tail?
It seems critical, but maybe it's just cosmetic.
Also, how much should I be paying for instalation?
Thanks.
ANSWER: The bracket is not necessary for the exhaust..........Triumph used the exhaust to support the fender, not the fender to support the exhaust. It should take NO more than an hour and a half to install.
QUESTION: Is there any drilling required?
ANSWER: one 1/4" hole for the lic light
QUESTION: Where are the turn signals now located? I can't tell from the picture.
ANSWER: on the heat sheild
Ask your question here:
Your email (so we can send you the answer):
powered by
