Application Chart Diagrams
Application
2000 Honda RC 51
2001 Honda RC 51
2002 Honda RC 51
2003 Honda RC 51
2004 Honda RC 51
2005 Honda RC 51
2006 Honda RC 51
Why buy a BRAKE PRESSURE SWITCH ASSY? Coarse or Fine?
These universal switches allow rearset users to operate the rear brake light. This all-in-one unit replaces the banjo bolt that connects the rear master cylinder to the rear brake line. You simply replace the bolt with this assembly and splice the wires into your existing brake light switch. The pressure inside your brake system then activates the brake light.
This part is a MUST HAVE item if you are going to ride your Woodcraft Race Rearset equipped bike on the street. Woodcraft Race Rearsets do NOT have a mount for your brake light switch linkage. This switch comes with a replacement banjo bolt and a pressure sensor switch that senses when pressure is applied, and triggers your brake light. The thread pitch can vary between different bikes IN THE SAME MODEL YEAR. Please make certain which thread pitch your specific bike has before ordering.
NO RETURN OR REFUND ON THIS ITEM!
WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations.
The Q&A on this Product
QUESTION: Do you use your exsisting pedals and heel guards?
ANSWER: On the brake side, yes - the shift side has an integral heel guard.
QUESTION: Do these rearsets sit your feet higher and further back than the stock items?
ANSWER: Yes, rise up and back 1 inch each way.
QUESTION: Hi,
Got a few questions
#1 do you accept paypal?
#2 do you have this item in stock? I plan to place the order tomorrow morning.
#3 I plan to use my stock shift and brake pedals, do I have to worry about getting something to activate my rear brake light?
ANSWER: We do not accept paypal, and besides this question comes from one of our dealer's website.
These are in stock. You can use your OEM pedals but you will still need to replace your rear brake light set up for street use. We offer a pressure activated brake light switch assbly. It's easy to install and retails for $17.99 The RC51 takes a coarse thread #03-0100.
Ask your question here:
Your email (so we can send you the answer):
powered by
