Why buy a BRAKE PRESSURE SWITCH ASSY? Coarse or Fine?
These universal switches allow rearset users to operate the rear brake light. This all-in-one unit replaces the banjo bolt that connects the rear master cylinder to the rear brake line. You simply replace the bolt with this assembly and splice the wires into your existing brake light switch. The pressure inside your brake system then activates the brake light.
This part is a MUST HAVE item if you are going to ride your Woodcraft Race Rearset equipped bike on the street. Woodcraft Race Rearsets do NOT have a mount for your brake light switch linkage. This switch comes with a replacement banjo bolt and a pressure sensor switch that senses when pressure is applied, and triggers your brake light. The thread pitch can vary between different bikes IN THE SAME MODEL YEAR. Please make certain which thread pitch your specific bike has before ordering.
NO RETURN OR REFUND ON THIS ITEM!
WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations.
The Q&A on this Product
QUESTION: I have a 2003 Kawasaki Ninja ZX-6R 636 and am interested in your product. But I don't know for sure which brake pressure switch assembly I'm going to need. Is there any way you can tell me whether I need the 10mm x 1.25mm or 10mm x 1.00mm?
ANSWER: You need a coarse thread brake light switch assembly our P/N 03-0100.
QUESTION: Do these rearsets fit a 2005 zx6r
ANSWER: No, the 2005 takes part number 05-0145.
QUESTION: Do any aftermarket pegs designed for the 636 work with the Woodcraft 636 brackets?
ANSWER: If they work on the stock 636, they will work on the Woodcraft brackets
QUESTION: Hello there,
I have the 03-04 kawasaki 636 zx6r,
do you have just the clutch side for this bike?
If so, how much will this put me back at?
THANKS
Dave.
ANSWER: We will sell any individual part for these bikes. One side rearset plate is $75.
QUESTION: What is the cost of the right side rear set only. 2006 Ninja ZX6R (636)
ANSWER: The cost is $75
QUESTION: I only need the clutch side rear set.. is there any way I can purchase one side
ANSWER: Yes, you can get any single part that you need for our rearsets.
QUESTION: Will my stock pedals work with these?
ANSWER: Yes, they will. You can upgrade to the three piece pedals at any time.
Ask your question here:
Your email (so we can send you the answer):
powered by
