Woodcraft Rearset Kit (with shift pedal) - Kawasaki 650R Ninja
The complete rearset kit consists of the rearset plates, footpegs, 3 piece billet shift pedal and all of the needed hardware (shift rods, etc) to install the kit properly.This kits saves almost 7 pounds and allows for both standard and GP shifting. Note: Photo shows full kit with both pedals. Brake pedal not included with this kit.
Item no. 05-0128
Retail: $334.99(PLUS shipping)
Today$329.98
Application Chart Diagrams
Application
2006 Kawasaki EX 650R NINJA
2007 Kawasaki EX 650R Ninja
2008 Kawasaki EX 650R Ninja
Why buy a BRAKE PRESSURE SWITCH ASSY? Coarse or Fine?
These universal switches allow rearset users to operate the rear brake light. This all-in-one unit replaces the banjo bolt that connects the rear master cylinder to the rear brake line. You simply replace the bolt with this assembly and splice the wires into your existing brake light switch. The pressure inside your brake system then activates the brake light.
This part is a MUST HAVE item if you are going to ride your Woodcraft Race Rearset equipped bike on the street. Woodcraft Race Rearsets do NOT have a mount for your brake light switch linkage. This switch comes with a replacement banjo bolt and a pressure sensor switch that senses when pressure is applied, and triggers your brake light. The thread pitch can vary between different bikes IN THE SAME MODEL YEAR. Please make certain which thread pitch your specific bike has before ordering.
NO RETURN OR REFUND ON THIS ITEM!
WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations.
The Q&A on this Product
QUESTION: How would you seat a passanger if you went with these rearset could you or would you have to do away with your passenger pegs
ANSWER: These do away with the passenger pegs - they are meant for the track
Ask your question here:
Your email (so we can send you the answer):
powered by
