Woodcraft Rearsets (without pedals) - Kawasaki ZX6 (07-08)
The basic rearset kit consists of the rearset plates, footpegs and all of the needed hardware (shift rods, etc) to install the kit properly. These kits assume that you currently have the OEM rearsets on your bike, and utilize the OEM shift and brake pedals. They are made from tough, aircraft grade 6061 T6 Aluminum. They are much stronger than OEM brackets and will give your bike a look that will separate you from the crowd.
This kit is designed specifically for the 07 ZX6R to give you the optimum foot position and ground clearance for racing. There are 6 possible locations for the eccentric pegs. This kit is upgradeable at any time to accept the CFM 3 piece billet shift and brake pedals.
Moves pegs up 3/4" (adjustable +/- 1.4") and back 1/2" (adjustable +/- 1/4")
Item no. 05-0147
Today$223.08
Application Chart Diagrams
Application
2007 Kawasaki ZX 6R Ninja
2008 Kawasaki ZX 6R Ninja
Why buy a BRAKE PRESSURE SWITCH ASSY? Coarse or Fine?
These universal switches allow rearset users to operate the rear brake light. This all-in-one unit replaces the banjo bolt that connects the rear master cylinder to the rear brake line. You simply replace the bolt with this assembly and splice the wires into your existing brake light switch. The pressure inside your brake system then activates the brake light.
This part is a MUST HAVE item if you are going to ride your Woodcraft Race Rearset equipped bike on the street. Woodcraft Race Rearsets do NOT have a mount for your brake light switch linkage. This switch comes with a replacement banjo bolt and a pressure sensor switch that senses when pressure is applied, and triggers your brake light. The thread pitch can vary between different bikes IN THE SAME MODEL YEAR. Please make certain which thread pitch your specific bike has before ordering.
NO RETURN OR REFUND ON THIS ITEM!
WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations.
The Q&A on this Product
QUESTION: So my oem brake lever and and shifter will fit right on to these rear sets? thanx eric
ANSWER: Yes, they will. Although our shifter has a little adjustability that allow you to fine tune the feel a little better than OEM.
Ask your question here:
Your email (so we can send you the answer):
powered by
