Rumble - KAWASAKI ZX636R 2005-06 FENDER ELIMINATOR BONE SERIES
This RUMBLE CONCEPT “Fender eliminator” Bone series is made of 16
gauge sheet metal and incorporates a new designed laser cut logo.
This «bone bracket» use flenges on each end that allows you to mount
any short stalk signals (1/4'' shaft) you want.
It also includes a strong white led light to illuminate the plate.
Installation is a snap by using the holes of the stock fender and without any drilling
or cutting, the New RUMBLE CONCEPT «Fender eliminators» are the nicest
and the finest quality available.
If you’re looking for that special touch of detail for your bike, the RUMBLE CONCEPT
«Fender eliminator» is the answer with it`s nice powder coated finish.
Item no. RU27224
Today$87.09
Application Chart Diagrams
Application
2005 Kawasaki ZX 6R Ninja (636)
2006 Kawasaki ZX 6R Ninja (636)
WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations.
The Q&A on this Product
QUESTION: how hard is it to put this product on the bike?
ANSWER: it is very easy and made for easy instalation the instructions are made easy to understand with pictures.
QUESTION: I bought this item and it looks like the distance between the holes are too narrow for a California license plate. Is this product meant to be compatible for Canada license plates?
ANSWER: This product is meant to be universal, please send me a picture at showler.k@rumbleimport.com and send me the distance between the holes that you feel it should be or that you have, we will clear this up.
QUESTION: This fender eliminator fits around the stock undertail exhaust? and will it fit if we have afftermarket exhaust? thanks
ANSWER: the fender may not fit if the stock exhaust was changed
QUESTION: I have the 2006 Kawasaki 636 ZX-6R, are there Really no drilling or cutting? Do I have to take off the tail section of my bike too? Thanks
ANSWER: In order to install the tail section must be removed, this product is installed on the original holes of the stock section.
QUESTION: I, too, would like to see the product installed on the bike. It's very hard to visualize how it would function.
ANSWER: We have no pictures of this product installed, maybe for a better visual go to www.rumbleconcept.com
QUESTION: i would like too see a picture of product on bike.
ANSWER: We have no available pictures of this installed.
Ask your question here:
Your email (so we can send you the answer):
powered by
