Rumble - Kawasaki ZX10R (06-07) FENDER ELIMINATOR BONE SERIES
This RUMBLE CONCEPT «Fender eliminator» Bone series is made of 16 gauge sheet metal and incorporates a led plate light, includes hardware (braket, bolts, bushing) and instructions. . .
Item no. RU27260
Today$87.09
Application Chart Diagrams
Application
2006 Kawasaki ZX 10R
2007 Kawasaki ZX 10R
WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations.
The Q&A on this Product
QUESTION: Looking for a fender eliminator for a 2008 Kawasaki ZX10. Figured if anyone had them yet it would be you guys...
Any luck?
-Jeff
ANSWER: The part for the 2008 ZX10 is RU36417. It is in production at this time and will be ready in 5 weeks
QUESTION: where and how does the LED mount, does a hole have to be drilled?
ANSWER: the licence plate light mounts under the bracket there is a place for it. No hole to be drilled
QUESTION: I have an 07 zx10r will this eliminator fit like it shows in the picture shown here? do you ship to australia and how much will it cost?
ANSWER: Yes it should fit. Ask 1tail for shipping cost.
QUESTION: Could you post a pic in the dark with some sort of plate?
ANSWER: i'm sorry we do not have the part mounted to a bike to take pictures in the dark
QUESTION: You did not answer my questions. Do the LED lights aim downward to light the license plate as well as the logo? The state of Virginia requires a white light to illuminate the license plate on the rear of the bike. This fender eliminator has white LED’s that obviously light up the ZX-10 logo, but does it also serve as a license plate light by directing light downward on the license plate?
ANSWER: This led plate light, does light some of the plate, but no replacements are DOT approved, and this is an optional light, it can be installed with the original light.
QUESTION: Are the LED's on this fender eliminator for the purpose of lighting the license plate as well as the ZX-10R logo or just for lighting the logo.
ANSWER: We are changing this product to 1 super bright led light with this fender kit, I will send the correction today. The 3 lights did not light better than 1 super bright led plate light.
QUESTION: Why wont the stock turn signals fit with this product
ANSWER: The bracket was not made to use the original stalk signals, the length left is for a short stalk only
QUESTION: Its the 2006 zx10 the turn signals are not apart of the eliminator the are flush with the tail cowling so why are aftermarket signals needed? You can still see the stock signals in the picture.
ANSWER: yes but there are chances you might not see the stock lights its like a warning so that you know they might not be visible.
QUESTION: Why would the stock turn signals not fit with this eliminator?
ANSWER: because it is not the stcok eliminator. Otherwise it would fit .
QUESTION: will my factory flush mounts still control my turn signals on the rear of the bike? Is there any drilling involved?
ANSWER: This will not affect your light system at all, no drilling involved.
QUESTION: Can the stock turn signals still be utilized with this product?
ANSWER: The wtock turn signals will not fit when this product is installed
Ask your question here:
Your email (so we can send you the answer):
powered by
