Woodcraft Complete Rearset Kit - GP Shift (Both Pedals) Yamaha YZF R6 (06-08)
The complete rearset kit consists of the rearset plates, footpegs, 3 piece billet pedals and all of the needed hardware (shift rods, etc) to install the kit properly. This kit also includes a mounting point for the stock muffler. They are made from tough, aircraft grade 6061 T6 Aluminum. They are much stronger than OEM brackets and will give your bike a look that will separate you from the crowd. This kit is designed for the new R6 to give you the optimum foot position and ground clearance for racing and has already been tested and tried at Daytona.-Rise up/back:5/8"/ 5/8". Use for GP shifting.
Item no. 05-0449B
Retail: $349.99(PLUS shipping)
Today$331.99
Application Chart Diagrams
Application
2006 Yamaha YZF R6
2007 Yamaha YZF R6
2008 Yamaha YZF R6
Why buy a BRAKE PRESSURE SWITCH ASSY? Coarse or Fine?
These universal switches allow rearset users to operate the rear brake light. This all-in-one unit replaces the banjo bolt that connects the rear master cylinder to the rear brake line. You simply replace the bolt with this assembly and splice the wires into your existing brake light switch. The pressure inside your brake system then activates the brake light.
This part is a MUST HAVE item if you are going to ride your Woodcraft Race Rearset equipped bike on the street. Woodcraft Race Rearsets do NOT have a mount for your brake light switch linkage. This switch comes with a replacement banjo bolt and a pressure sensor switch that senses when pressure is applied, and triggers your brake light. The thread pitch can vary between different bikes IN THE SAME MODEL YEAR. Please make certain which thread pitch your specific bike has before ordering.
NO RETURN OR REFUND ON THIS ITEM!
WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations.
The Q&A on this Product
QUESTION: How do i find out witch brake pressure switch the 10mmx1.25 or the 10mmx1.00 for the Yamaha Yzf R6 2007. (coarse or fine thread.)
ANSWER: The Yamaha uses the coarse thread 1.25mm switch.
QUESTION: will these rearsets fit a 2007 r6 yamaha
ANSWER: Yes, the definitely will.
Ask your question here:
Your email (so we can send you the answer):
powered by
